BDGP55240/830/2C GIMAX United States Sales

BDG- 55W 24V WARM LIGHT 830 Dulux polycarbonate d. 50mm+n.2 OBO/01 Lamp composed as follows: OUTER ENCLOSURE POLYCARBONATE tube with excellent transparency and gloss characteristics. Outstanding chemical resistance to mineral acids at medium concentration, to alcohols with the exception of alcohol methyl, to aliphatic hydrocarbons (oils and fats). The maximum operating temperature for continuous use 100°C. Tube thickness 1.5mm outer diameter 50mm SIDE CLOSURES Side closures in TAROPLAST material (Taromid A 280 MT6) 6.6 loaded at 30% (PA6.6+) 30% F.V.) reinforced with glass fiber (Glow wire test 960°). Each clasp is made from two parts distinct: the innermost part has the task of keeping the internal screen locked (described below) and incorporates 3 threaded brass inserts drowned during molding. The outside part comes tightened to the inner one by means of 3 stainless steel screws through. At the time of tightening of the closing screws, the seal inside is compressed against the tube, obtaining thus an effective protection against water and dust infiltration. GASKETS BAYER silicone-based O-RING sealing gaskets in red color. Characteristics of excellent heat resistance (250°C), excellent resistance to low temperatures and flexibility in cold weather (-60°C). Excellent stability. Excellent aging resistance and great stability to ozone and ultraviolet rays. Excellent dielectric behavior over a wide range of temperature. excellent elastic characteristics in the wide range of hardnesses that can be supplied. Great stretch to break. Excellent dimensional stability. Complies with BGA, FDA, KTW regulations. INTERNAL SUPPORT Reflective screen in extruded aluminum and painted white, for maximum performance bright, with the function of supporting the converter (where provided) and the fluorescent tube. GENERAL CHARACTERISTICS Insulation class...: I (CEI 64-8 and CEI 17-13/1 standards). Degree of protection...: IP67 (IEC 529 and CEI 70-1 standards). CE marking and construction in accordance with CEI 34-21 EN 60598-1 and CEI 34-29 EN 60598 -2-4. The lamp is equipped with: - No. 1 fluorescent lamp type DULUX L (OSRAM), 55W power (high efficiency 4800 lumens), Color 830 WARM light, temperature of color 4,500 degrees Kelvin and nominal life equal to 8,000 hours of operation). - No. 1 PG9 cable outlet, IP68 degree of protection, complete with anti-tear device, placed laterally to a closure. - No. 1 F.L.D. (Fluorescent Lamp Driver) power supply in H.V.I.C. C-MOS (Hi Voltage) technology Integradet Circuit) with low dispersion, operating at high frequency (32 kHz) to optimize the longevity of the lamp, trigger Instantaneous light flux and suppression of the stroboscopic effect normally present and visible in traditional power supplies operating at network frequency. Complies with EN61547, EN55015 and EN60928 regulations on radio disturbances, electrostatic discharges and protection against possible anomaly states of the lamp. Ballast temperature...: from -10°C to +50°C Supply voltage...: 24V +/- 10% A.C. Lamp length...: 773mm Lamp with 2 mounting brackets included Art. OBO/01